Pro tip: If your basement is unfinished, you can go down there to see on the ceiling where exactly the pipes go up. Most stud finders are iffy at best on plaster and lathe.

Comfortably hold in either hand at any angle while the rubber over-molded grip. When it finds a stud in the wall, it shows the width by illuminating some of its seven LEDs: Whichever are over the stud will turn on, and whichever aren’t will remain off. It features four scanning modes and a graphical LCD display for a range of cues including detection mode, signal strength, automatic calibration, and battery indication. Surprisingly, it picked up the edges somewhat early under half-inch drywall—but marking both edges and measuring to the midpoint still got us to the stud’s center. If you just want to locate a stud, Stanley’s basic S50 is all you need. Magnetic stud finders use a very simple concept: the nails that hold studs together are magnetic, and so are dry wall fixings. (Though in fairness, the pipes were four inches apart, a sure indication they weren’t studs.) Today’s stud finders can also pack an extra punch: Many are outfitted with features that extend the usefulness of the stud finder and make it handier. Therefore it doesn't detect the stud itself but rather the hardware that attaches the wall material to the stud. Its small profile is easy enough to store in a drawer or toolbox until you need it, and its whole-stud detection meets the needs of full-time Pros. In our experience, metal detecting gives us the best results. When you locate a nail or screw, you’ve located a stud. The StudSensor A100 accurately located the edges of metal and wood studs through up to three-quarter-inch drywall. Scanning slowly in one direction, past the center and then back, got us accurate results over half- and three-quarter-inch drywall. Please read and accept our website Terms and Privacy Policy to post a comment. Different materials in the floors, … In addition to the large LCD screen, the red, green, and yellow indicator lights provide visual feedback. A vertical beam is helpful to mark the entire length of the stud. Detection is achieved using two different methods: Uses powerful magnets to pinpoint the location of screws or nails in a stud. The Franklin FST602 (T6) also provides the same functionality in a more compact package for $24.99. There's a problem loading this menu right now. Studs are typically 16 inches apart (walls) and occasionally 24 inches (ceilings). Our team will put our hands on hundreds of additional tools at media events and trade shows throughout the year. We may earn commission if you buy from a link. Magnetic stud finders, both stationary and moving, are less expensive, smaller and easier to use than electronic devices. Quint gp pointer is better than any stud finder that I know of. Magnetic stud finders are very affordable. Without the ability to electronically sense the sides and center, it’s important to get the stud finder level so you can more easily follow the stud. Simple options like StudPop work well, but the CH Hanson Magnetic Stud Finder had the most appeal to our team. Stud finders are great for locating the studs behind your walls. One’s not inherently better than the other; rather, each one offers different benefits for different situations. It can also detect live AC wiring, metal objects, plastic pipes that are filled with water, and even rebar in concrete.